Installation Procedure And Minimum Clearances - Delta Electronics ASDA-B2 series User Manual

VARITEL INGENIERIA ELECTRONICA S.A.
ASDA-B2 Chapter 2 Installation and Storage

2.4 Installation Procedure and Minimum Clearances

Installation Procedure
Incorrect installation may result in a drive malfunction or premature failure of the drive and
or motor. Please follow the guidelines in this manual when installing the servo drive and
motor.
The ASDA-B2 servo drives should be mounted perpendicular to the wall or in the control
panel. In order to ensure the drive is well ventilated, ensure that the all ventilation holes
are not obstructed and sufficient free space is given to the servo drive. Do not install the
drive in a horizontal position or malfunction and damage will occur.
Drive Mounting
The ASDA-B2 servo drives must be back mounted vertically on a dry and solid surface
such as a NEMA enclosure. A minimum spacing of two inches must be maintained above
and below the drive for ventilation and heat dissipation. Additional space may be
necessary for wiring and cable connections. Also, as the drive conducts heat away via the
mounting, the mounting plane or surface should not conduct heat into the drive from
external sources
Motor Mounting
The ECMA servo motors should be mounted firmly to a dry and solid mounting surface to
ensure maximum heat transfer for maximum power output and to provide a good ground.
For the dimensions and weights specifications of servo drive or motor, please refer to
Chapter 11 "Specifications".
Minimum Clearances
Install a fan to increase ventilation to avoid ambient temperatures that exceed the
specification. When installing two or more drives adjacent to each other please follow the
clearances as shown in the following diagram.
2-3
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.