Delta Electronics ASDA-B2 series User Manual page 109

Chapter 5 Trial Run and Tuning Procedure
NOTE
1) When bit0 of P2-33 is set to 1, it indicates that the system inertia estimation of semi-auto mode
has been completed and the measured load inertia value is saved and memorized in P1-37
automatically.
2) If reset bit0 of P2-33 to 0, it will start estimating the system inertia again.
5-16
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
ASDA-B2
Revision September 2013