Delta Electronics ASDA-B2 series User Manual page 208

ASDA-B2
P1-54 PER
Operation
Interface:
Default: 1600
Control
Mode:
Unit: pulse
Range: 0 ~ 1280000
Data Size: 32-bit
Display
Format:
Settings:
In PT mode, when the error pulse numbers is less than the setting value of parameter
P1-54, TPOS (At positioning completed signal) will be activated.
P1-55 MSPD Maximum Speed Limit
Operation
Interface:
Default: rated speed
Control
Mode:
Unit: r/min
Range: 0 ~ Max. speed
Data Size: 16-bit
Display
Format:
Settings:
This parameter is used to set maximum motor speed. The default setting is rated
speed.
P1-56 OVW
Operation
Interface:
Default: 120
Control
Mode:
Unit: %
Range: 0 ~ 120
Data Size: 16-bit
Display
Format:
Settings:
This parameter is used to set output overload time. If the setting value of parameter
P1-56 is set to 0 ~ 100, the function of parameter P1-56 is enabled. When the motor
has reached the output overload time set by parameter P1-56, the motor will send a
warning to the drive. After the drive has detected the warning, the DO signal OLW will
Revision September 2013
info@varitel.com - www.varitel.com - Tel. (54) 11-4243-1171 / Fax: (54) 11-4292-7545
Manuel Baliña 456, Lomas de Zamora (B1832CCJ) Buenos Aires, Argentina.
VARITEL INGENIERIA ELECTRONICA S.A.
Positioning Completed Width
Keypad/Software
PT
Decimal
Keypad/Software
ALL
Decimal
Output Overload Warning Time
Keypad/Software
ALL
Decimal
Chapter 7 Servo Parameters
Communication
Communication
Communication
Address: 016CH
016DH
Related Section:
Table 7.B
Address: 016EH
016FH
Related Section: N/A
Address: 0170H
0171H
Related Section: N/A
7-43