Table of Contents
Advertisement
9.2.4
Assigning DSP to Sum Busses
On POWER CORE, all summing busses are added to the configuration without signal processing. Therefore, if
you wish to apply DSP, the modules must be enabled on a bus-by-bus basis.
1.
Select the summing bus you wish to edit from the Sum Bus branch of the system tree, and select the
Parm menu tab.
2.
Use the Limiter, Compressor, Equalizer and/or Delay checkboxes to enable each processing module.
The signal processing is described in more detail later, see
You can keep track of how many resources are available by opening the "Command -> Resources" window.
94/459
DSP
Parameters.
Version: V6.0.0/5
9. Audio Mix Engine
POWER CORE User Manual
Advertisement
Table of Contents
