Table of Contents
Advertisement
The following fader status outputs are available for each source. You can use these to trigger other logical
functions via the 'Tree Selection' window.
Fader Start
For moving fader systems:
·
In Normal mode the output indicates the status of the RAS/Logic controlled surface fader
position.
·
In Hot Fader mode, the output indicates the status of the RAS/Logic controlled background
fader position.
For non-moving fader systems, the output is active when the "Background" fader (RAS/Logic)
value is open.
nFader Start
The negative result of Fader Start.
Fad. -20dB
Becomes active when the "Background" fader value moves above -20dB.
Becomes inactive when the "Background" fader value is off.
Fader Man. Start
For moving fader systems:
·
In Normal Mode the status is true by default.
·
In Hot Fader Mode, the output reflects the surface fader position.
For non-moving fader systems, the output reflects the status of the physical fader position. It is
active when the "Surface" fader value is open.
Fader Man. nStart
The negative result of Fader Man. Start.
Fader Man.
Becomes active when the "Surface" fader value moves above -20dB.
-20dB
Becomes inactive when the "Surface" fader value is off.
Fader Result Start
Active if Fader Start AND Fader Man. Start are both active. If a VCA master is assigned, then
this also needs to be active.
In Normal mode this output is identical to Fader Start.
In Hot Fader mode, this output flags the status of the combined physical fader and RAS/logic
controlled fader position. In other words, both the physical fader and the automation/logic need
to be open for this output to be true.
Fader Result nStart
The negative result of Fader Result Start.
Fader prepared
Active if Fader Start is active AND Fader Man Start is NOT active.
Use this output in Hot Fader mode, or on non-moving fader systems, to flag when the RAS or
logic has opened a fader position, but the physical surface fader is closed.
Fader Touch active
Active if the fader sense is active (the fader is touched).
Selecting Hot Fader Mode
For moving fader systems, the operator can enable (or disable) Hot Fader Mode from the SYS menu.
The initial value, which is active following a cold start, is defined in the
Fader" branch of the 'Tree Definition'.
90/459
"System -> Definition -> Parameter =
Version: V6.0.0/5
9. Audio Mix Engine
POWER CORE User Manual
Advertisement
Table of Contents
