Table of Contents
Advertisement
18.27.2 Ember+ Internal Src Query
An Ember+ Internal Src Query allows you to query the value of a specific Ember+ parameter path. It can be
used to report back the status of a parameter value to the operator - for example, to light an MF Key or VisTool
indicator if a value exceeds a certain threshold, or is on (or off).
For each element (parameter path), up to four conditions can be compared using equal to (=), greater than (>) or
lesser than (<). Each active condition produces a true and false output.
Global Parameters
Internal SrcQuery
Source/Sum
Parameter Path
Condition 1 to 4:
Parameter Value
The Param Path and Value fields can be identified using an Ember Viewer as shown below. In our example, the
Param Path for the Mic1 source is indicated in green/red, and the Values in orange - for parameters such as
release time, an integer value specifies the list position (e.g. 4 = 200ms):
352/459
18. Configuring Custom Logical Behaviour
Reference name for the element.
Assign the source or summing bus you wish to interrogate.
Enter the parameter path you wish to interrogate.
Enter the parameter values and logical conditions you wish to interrogate - you may run up
to four individual queries. For each query, select the logic from the drop-down menu (=. >,
<), enter the parameter value and tick the active checkbox. Note that the query must be
ticked as active to produce a 'Tree Selection' output.
In our example, if the Compressor Release Time is less than 4, Condition 1 = true; if the
Release Time = 4, Condition 2 = true, and so on. (In our example, the value of 4 = 200ms
according to the
Ember+ Enumerations
Version: V6.0.0/5
table.)
POWER CORE User Manual
Advertisement
Table of Contents
