Table of Contents
Advertisement
Fader Down
Closes the source fader (see also Hold Mode below).
Fader Toggle
Changes the state of the source fader: open to closed, or vice versa (see also Hold Mode
below)
Fader Up to Last
Value
Opens the source fader to its last known position.
Fader Toggle to Last
Toggles the source fader to its last known state.
Value
These 5 functions can be used to programme a fader start and are triggered by the rising edge
of the input control signal.
Hold Mode
When this input is active, the last position is stored when the fader is closed by Fader
Down/Toggle. Opening the fader using logic sets the fader to the last stored position. If Hold
Mode is activated while the fader is closed, then the Default Position set below is used.
Default Pos (dB)
Used in conjunction with Hold Mode. Sets the default level, in dB, to which the fader will open if
Hold Mode is activated while the fader is closed.
DMS Color
The value entered here selects the colour for DMS meters within VisTool (see VisTool Editor:
PPM). The value shown is represented by 0xRRGGBB where RRGGBB denote the amounts of
Red, Green and Blue respectively. Click on the colour selector box to choose from the colour
palette.
Source Color
Selects the colour used to illuminate the fader strip backlight when the Mode is set to either:
·
Source Color Enabled
·
Mix Mode
If you select Black, then the backlight is unlit.
Source Color Mode
Select the mode of operation for the fader strip backlight:
·
Source Color Enabled - always indicates the type of source.
·
Source Color Disabled - always indicates signal present.
·
Mix Mode - combines the options above; signal present takes priority.
Signal present parameters are defined under
Present"..
Channel On Edge
When a positive edge is supplied to this input, the source is unmuted.
Channel Off
When a positive edge is supplied to this input, the source is muted.
Edge
This input toggles the status of the channel mute on each rising edge of the control signal.
Ch On/Off Toggle
This input mutes the source as long as it is supplied with an active control signal.
Channel Mute
These 4 control inputs allow the audio signal of a source to be switched on and off.
Access User Off
This input locks out the Access Key so that the source cannot be assigned to the centre
section. You may use this to limit operator access to source parameters.
Parm Page User Off
This input locks out all DSP modules for the source. You may use this to prevent parameters
such as a presenter's mic EQ and Compression from being altered by the operator.
Channel Parm off
This input locks parameter control from the channel fader strip. You may use this to prevent
parameters such as mic gain and pan from being altered by the operator.
Ref Src
Selects the reference source. When a source is assigned to the control surface, a reference
source can be assigned at the same time. For example, on a console with two layers – on-air
and record – you could assign the TEL source to both layers automatically. In this parameter
box, assign the reference source (e.g. TEL).
To determine where the reference source appears on the control surface, use the Ref Src
Fader Offset option set within the
Note that changing DSP parameters on one of the sources will affect the other.
Matrix Mic Nr
These two fields are used if the audio input to the source is a microphone which requires
arbitration. See
Matrix Gnet Port
Use the Matrix Mic Nr field to enter the
configuration.
In the Matrix Gnet Port field, enter the
80/459
.
"System -> Definition -> Param =
Mic
Arbitration.
Version: V6.0.0/5
9. Audio Mix Engine
"System -> Definition -> Parameter = Signal
Mic Input Nr
referenced within the server's
GPI/O Network
port number which connects to the server.
Fader".
POWER CORE User Manual
Advertisement
Table of Contents
