Table of Contents
Advertisement
Group Fader Values
Fallback
Display Hold Time (sec)
Motor Fader Open
Manual Fader Open
Vistool Fader is
Dim Source Colours
User Labels On
User Labels Off
User Labels Toggle
Enable Large User Labels
Global switch to Layer 1
Global switch to Layer 2
Swap ACCESS Keys
Save Channel On/Off
Fader Notch (initial)
Hot Fader Mode (initial)
Freeze all Channels
210/459
Applies if Show Group Fader Values is active.
Select this checkbox if you wish the fader strip display to revert to its default mode (e.g.
source name) after the Display Hold Time (see below).
This is the time in seconds before the fader strip display returns to its default (e.g. source
name) after the rotary control on a fader strip has been pressed or VCA group levels have
been displayed.
Initially sets the
"Background
used for RAS control or the
Fader Up/Down/Toggle
you should set the fader to open (as the fader is always in the signal path).
Initially sets the
"Surface
fader" to open. If you do not have a surface attached and use
logic, RAS or any other protocol for fader control, you may set the fader to open (as the
fader is always in the signal path).
Choose the fader which is shown and controlled in the Vistool. Motor Fader represents the
"Background fader", while Hot Fader represents the "Surface fader". See
Sets defined source colours to dim.
These control inputs switch User Labels on or off, or toggle their state. They can be used
to configure how operators view User Labels on the surface.
This control input switches User Labels on the surface to large display mode.
Assigns a control input to switch all Fader Modules enabled for layering to Layer 1.
Assigns a control input to switch all Fader Modules enabled for layering to Layer 2.
Swaps the function of the Fader Module ACCESS keys 1 and 2. If
Fader Module, then ACCESS 1 and MF 5 are swapped.
If ticked, the Channel On/Off parameter of sums and sources is stored and recalled by
snapshots and memories.
Sets the initial value (active after a cold start) for the System menu's Fader Notch option.
Sets the initial value (active after a cold start) for the System menu's
Assigns a control input which will disable controls on the Channel Module. You might
activate this mode to dust the console!
Version: V6.0.0/5
13. Control Surface Configuration
fader" to open (after coldstart). The Background fader may be
logic. If you do not use any of these,
Fader
Status.
Layer 2 is disabled
in a
Hot Fader
Mode.
POWER CORE User Manual
Advertisement
Table of Contents
