LAWO POWER CORE User Manual page 218

13. Control Surface Configuration
Multi-frame Configuation
For a multi-frame configuration you will need to adjust the CAN bus addresses on the physical modules (using
the special functions mode).
By setting the CAN bus address to match the Frame -> Surface configuration, you can define which frames will
control the different sets of fader strips; which frame includes the Central Module (Address 10); and which
frames include monitor mode Central Modules (if applicable).
Frame -> Surface menu: ruby 15 + 1 +6 Example
Control Surface Layers (Fader Mappings)
Each Fader Module supports two layers. This means that the module set to hex address 01 controls fader strips
1 to 4 (Layer 1) and 5 to 8 (Layer 2); the module set to hex address 02 controls fader strips 9-12 and 13-16; and
so on. The diagram below illustrates all the fader strip mappings. A single control surface can support up 60
physical fader strips, each with two layers:
Fader Mappings
218/459 Version: V6.0.0/5 POWER CORE User Manual