LAWO POWER CORE User Manual page 129

9. Audio Mix Engine
In State
Pushout
Disable
Reset
Preset
The individual control outputs of the TConn64 appear under the "Logic -> <GroupName> -> TConn64" of the 'Tree
Selection' window. In addition, you will find the element's Out State under "Element State -> GroupName ->
TConn64".
Cascading TConn64 & Button 16/64 Elements
The Global -> In State of a TConn64 can be assigned to the Out State of another TConn64,
Button64 in order to cascade elements. The Out State of the master element should be assigned to the In State
of the slave. The slave will then follow all switch changes which occur in the master.
POWER CORE User Manual
Can be assigned to the OutState of another TConn64, a
cascade elements (see below).
Or, to the Save Out state from a
in order to respond to snapshot recalls.
When checked, Pushout is active.
Inhibits the setting of another trigger.
This control signal resets the TConn64. It can be used to define a default connection
which is activated by the Reset control signal.
If Pushout is active, and the Reset control signal is triggered then Audio In PO 1 and 2 are
assigned to Audio Out 1 and 2.
If Pushout is not active, and the Reset control signal is triggered then the Preset inputs
(below) are assigned to Audio Out 1 and 2.
Enter the number of the audio input which you wish the TConn64 to reset to when Reset is
actioned. This is also the state which the TConn64 will reset to after a
Version: V6.0.0/5
Button16
System Defintion -> Parameter = ElementState
or Button64 in order to
snapshot
cold start.
Button16 or
129/459