9. Audio Mix Engine
9.2.3
Sum Bus Parameters
Select the Sum Bus you wish to edit in the 'Tree Definition' and open the Parm tab to access its main
parameters:
There are identical to the corresponding
·
DSP must be allocated to each summing bus by ticking the Limiter, Compressor, Equalizer and/or
Delay boxes.
·
Post Only – select this checkbox to limit bus assignments to post fader only (e.g. for a Main or Group
bus).
Note that you cannot assign a sum bus to another sum bus or conf bus. To achieve, you will need to assign the
sum bus to a loopback output, and then assign the loopback return as the input to a source. The source may
then be assigned to the sum bus in the usual manner. Audio loopbacks will be described later.
POWER CORE User Manual
Source
parameters, with the following exceptions/additions:
Version: V6.0.0/5
93/459