Table of Contents
Advertisement
14.6.2 Logout
You can also use the 'Login' window, to "log out". This will leave the console in a default or safe state, as defined
by the console configuration.
1.
Re-open the
Login
2.
Select Logout.
The console may reset, for example to a safe (blank) state.
The logout state is controlled by the Administrator settings for the user called "Nobody". Therefore, it is the
login snapshot for the user "Nobody" which resets the console to a blank state, and the user rights for
"Nobody" which prevent access to console operation.
To change this behaviour, you must login as an Administrator and edit the login snapshot and user rights for
the user "Nobody" in the usual manner. See the
14.6.3 Changing Your Password
Once you are logged in, you may change your password as follows:
1.
Re-open the
Login
You should see that you are logged in as the Current User:
You cannot change your password if you are not logged in!
If you have forgotten your password, then an Administrator can reset it to 0000. Administrators, please see
Password
Reset.
There are no restrictions on the characters used for a password.
2.
Select Change Password.
3.
Enter your new password into both the Password and Repeat fields, and select OK:
4.
Test the new password by
234/459
window - the name of the Current User is displayed:
Admin Pages.
window.
logging out
and
logging
Version: V6.0.0/5
14. Snapshots System
in.
POWER CORE User Manual
Advertisement
Table of Contents
