Table of Contents
Advertisement
Fixed Assignments
The Only Default and Default Source options can be used to permanently assign a source or summing bus to a
fader strip:
1.
Double-click on the Fader Module you wish to configure from the
"Surface -> Fader Module" branch of the 'Tree Definition'.
2.
Double-click in the Default Source 1.1 entry field to assign a default source for Layer 1 fader strip 1:
3.
Repeat to assign a default source to each fader strip on the module:
·
Use fields 1.1, 1.2, 1.3, 1.4 for Layer 1, strips 1 to 4
·
Use fields 2.1, 2.2, 2.3, 2.4 for Layer 2, strips 1 to 4 (sapphire only).
These default assignments are loaded when the configuration is transferred, or the system is reset using a cold
start.
4.
If there are some fader strips which you do not wish operator's to re-assign (e.g. their microphone!), then
enable the Only Default option.
When Only Default is ticked, the Default Source is permanently assigned to the fader strip, and cannot be
removed or replaced.
190/459
13. Control Surface Configuration
Version: V6.0.0/5
Surface
configuration, or open the
POWER CORE User Manual
Advertisement
Table of Contents
