Table of Contents
Advertisement
Clear Rights on Start
Load PC Snap
Save PC Snap
Delete PC Snap
Save PC Source Snap
Log into PC
Edit PC Labels
Application Full Screen
Application WindowPos
Application Minimize
Application Close
Select 1 to 32
The control outputs appear under "Logic -> <GroupName> -> VispageSwitch" in the 'Tree Selection' window:
Selected 1
Selected 2
etc.
Use the Selected 1 to 32 outputs as feedback to the control signal (for example, to light the MF Key which
switched the page).
266/459
If checked, defined user rights are reset after a warm start (e.g. a power cycle). If not
checked, user rights will remain intact.
Note that you must be using VisTool MK2 to support the
When this control signal is active, a window opens on the VisTool screen to load a
snapshot.
As above, but to save a snapshot.
As above, but to delete a snapshot.
As above, but to save a source snapshot.
When this control signal is active, the user
You must activate this function to provide access to the user rights supported by VisTool
MK2.
The function should only be active on a single VisTool screen - i.e. for one VispageSwitch
element mapped to one Station Id.
When this control signal is active, the user label edit window opens on the VisTool
screen.
Sets the application to full screen view.
Toggles the application between full screen and minimized.
Minimizes the application.
Closes the application.
When the Select 1 control signal is active, the VisTool screen is switched to page 1,
where page 1 is the page index within the VisTool Editor configuration.
When the Select 2 control signal is active, the VisTool screen is switched to page 2.
And so on up to page 32.
True when Page 1 is selected.
True when Page 2 is selected.
Etc. up to 32.
Version: V6.0.0/5
15. Connecting a VisTool MK2 PC
user rights
log in
window opens on the VisTool screen.
POWER CORE User Manual
system.
Advertisement
Table of Contents
