LAWO POWER CORE User Manual page 225

14. Snapshots System
Enable
The following control outputs appear under "Logic -> Definition -> Parameter Snapshot" in the 'Tree Selection'
window:
Snapx.set
Snapx.load
Src Clipboard.set
Glb Snap loaded pulse
Src Snap loaded pulse
POWER CORE User Manual
When nothing is assigned, or the Enable box unchecked (see below), the SAVE and
ERASE functions are always available to the operator.
To protect the functions, assign an input control signal which must be True before SAVE
and ERASE become available.
To activate the Snap/XL Unlock control signal, the Enable checkbox must be ticked.
Active when data is stored to the internal snapshot memory. This can be used to signal
to the operator which memories contain settings and which memories are empty.
This output is pulsed when the snapshot is loaded.
Active when data is stored to the internal clipboard.
This output is pulsed when a Full snapshot is loaded.
This output is pulsed when a Src snapshot is loaded.
Version: V6.0.0/5 225/459