Table of Contents
Advertisement
20. Maintenance
20.3.1 First Steps
1.
Start the programme by selecting START -> Program Files -> OnAirDesigner -> SoP Explorer on your
PC.
This is the default file path created during a standard install.
2.
Select Unit -> New from the main menus, and enter the IP address of the Lawo system - for example, the
default address is 192.168.101.240. Then select OK:
SoP Explorer connects to the control system and analyses the current software revisions for each of the main
system components: Surface, System, etc.
3.
Use the + and - signs to open and close the system branches and view the status of each software module:
The default unit name is Zirkon. This can be edited from the
and wish to easily identify them within SoP Explorer.
SoP Explorer compares the current software revisions to the latest release files which were copied onto your
computer's hard disk during the ON-AIR Designer installation. If a software module is up to date, then you will see
a green tick (as shown above). If a different status icon appears, then you may need to update either the complete
system or an individual module. See
4.
Repeat steps 2 and 3 for each Lawo system connected to your network.
If you have multiple systems, it is a good idea to edit the system Name so that it can be easily identified.
POWER CORE User Manual
Checking the Software
Status.
Version: V6.0.0/5
Properties
window if you have multiple systems
407/459
Advertisement
Table of Contents
