LAWO POWER CORE User Manual page 89

9. Audio Mix Engine
9.1.9 Source Fader Behaviour
The fader status outputs are active depending on the status of the source fader.
Note that each control surface will behave differently depending on whether or not it supports moving faders. For
surfaces with moving faders, there is a choice of two modes: Normal or Hot Fader
surfaces with non-moving faders, there is no choice as the faders always operate in the equivalent of Hot Fader
Mode.
The two modes are shown in the diagram below.
·
Normal Mode – the surface fader position always represents the fader level. This means that if a source
is controlled by RAS or Fader Up/Down/Toggle logic signals, then the surface fader will move in response
to the automation.
·
Hot fader Mode – the surface fader position is independent of any automation (RAS or fader logic). This
allows an operator to preset a fader value (e.g. 0dB), before an RAS controller or Fader Up/Down/Toggle
fader start opens or closes the Background fader level.
Note that in Normal Mode, the Background level is always 0dB and has no action; in Hot Fader Mode, the
operator sets the Surface level, while RAS or fader logic signals control the Background level.
POWER CORE User Manual Version: V6.0.0/5
(described below). For
89/459