Table of Contents
Advertisement
4.
Before you select OK, check the snapshot Type:
·
Full snapshots store and recall all settings.
·
Source snapshots store settings for the source in access only (crystal & sapphire only).
5.
To load a Full snapshot, select it and OK - the snapshot settings are loaded to the system.
6.
Before loading a Source snapshot, check if there is a source in access:
·
If no, then the Source snapshot settings are recalled to the original source. This is the source which was
in access when the Source snapshot was saved.
·
If yes, then the Source snapshot settings are recalled to the source in access, providing that the Class
matches that of the original source. Note that if the Class does not match, then the parameters will not
load. The source Class is defined in the
7.
Select the Source snapshot and OK to load it - the snapshot settings are loaded accordingly.
If you are operating the snapshots system from VisTool, and the Display SnapShotName MF Key option is
configured, then the name of the current snapshot will appear on the display.
14.5.2 Saving & Erasing a VisTool snapshot
You can save or erase VisTool snapshots in a similar manner.
When saving snapshots, your system can be configured with one or both of the following buttons:
·
Save snap – saves a Full snapshot.
·
Save source snap – saves a Source snapshot with settings for the source in access (crystal &
sapphire only).
Use the
"System -> Definition -> Parameter =
Definition' to configure these functions.
When you save, you will be asked to enter a name for the snapshot and a comment.
230/459
Source -> Parm
branch of the 'Tree Definition'.
Snapshot" or
"Logic ->
Version: V6.0.0/5
14. Snapshots System
VispageSwitch" branches of the 'Tree
POWER CORE User Manual
Advertisement
Table of Contents
