Adjusting The Zone Settings - Native Instruments MASCHINE MK3 Manual

16.5.6

Adjusting the Zone Settings

At the bottom of the Zone
played back.
The Zone settings in the software.
The various sections always display the values for the focused Zone.
If the MASCHINE window is not wide enough to display all Zone settings at once, a hori-
zontal bar appears underneath to scroll to the desired section of parameters.
Following parameters are available:
(1) PLAY RANGE section
The parameters in the PLAY RANGE
be played back when the Zone is triggered.
Parameter
START
END
(2) LOOP section
The parameters in the
loop while the note is held.
page, the Zone settings allow you to adjust how each Zone should be
section allow you to adjust the portion of Sample that will
Description
Adjusts the playback's start point in the Sample of the focused
Zone.
Adjusts the playback's end point in the Sample of the focused
Zone.
LOOP section allow you to define and adjust a portion that will play in
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE - Manual - 874