Touch Auto-Write Option - Native Instruments MASCHINE MK3 Manual

▪ MASCHINE STUDIO controller: Press
desired instance, and press the jog wheel or Button 8 to load it.
▪ MASCHINE (MK1 & MK2) controller: Press
ton 5/6) to select the desired instance, and press Button 8 to load it.
▪ MASCHINE MIKRO (MK1 & MK2) controller: Press
to select the desired instance, and press the Control encoder to load it.
▪ MASCHINE JAM controller: Press
lect the desired instance, and press the Control encoder to load it.
▪ KOMPLETE KONTROL Keyboard MK1: Press
select the desired instance, and press the Control encoder to load it.
▪ KOMPLETE KONTROL Keyboard MK2: Press
lect the desired instance, and press the 4-D encoder to load it.
2.3.11

Touch Auto-Write Option

Modulation recording also benefits from the touch sensitivity of Knobs 1–8 via the Touch Auto-
write option.
Reminder: To record modulation from your MASCHINE controller, activate playback,
switch your controller to Auto-write mode by pressing and holding AUTO, and then turn
the Knobs 1–8 to adjust parameters. For more information, please refer to section
↑10.5.2, Recording
Enabled by default, the Touch Auto-write option allows you to record modulation events as
soon as you touch Knobs 1–8, even if you don't rotate them:
▪ If Touch Auto-write is disabled, modulation events are recorded only when you rotate the
Knobs 1–8 (as in previous MASCHINE versions).
▪ If Touch Auto-write is enabled, modulation events are recorded as soon as you touch the
Knobs 1–8, whether you actually rotate them or not:
◦ If you rotate the Knobs, the new modulation values are recorded for the corresponding
parameters.
SHIFT
SHIFT + H
Modulation.
+ PLUG-IN, turn the jog wheel to select the
SHIFT + STEP, turn Knob 8 (or press But-
SHIFT + F2, turn the Control encoder
(INSTANCE), turn the Control encoder to se-
INSTANCE and turn the Control encoder to
INSTANCE and turn the 4-D encoder to se-
Basic Concepts
Common Operations
MASCHINE - Manual - 58