Adjusting Quantization Using The Grid; Adjusting Pattern Length - Native Instruments Maschine Getting Started Manual

4.3.1

Adjusting Quantization using the Grid

The Step Grid property affects all Pattern editing actions, including quantization (note
snap). The default setting is 1/16th, however you may use another one or disable the Step
Grid completely.
Hardware
1. To change the Step Grid's quantization settings, press and hold the
the MASCHINE controller; the right display will show you which pad represents which
Grid.
2. Select a Step Grid resolution by pressing the corresponding pad.
► If you want to adjust the Pattern Grid (see section
press Button 3; then select a Pattern Grid resolution by pressing the corresponding pad.
Software
The area to the right of the Sound Slots is called Pattern Editor. To change the Grid of the
Steps, select a new value from the drop-down Grid menu.
The Grid menu.
4.3.2

Adjusting Pattern Length

Now that you have adjusted the Pattern Grid, let's adjust the Pattern Length as well.
Hardware
► To change the Pattern length, press the
the right will extend the Pattern, dialing to the left will shorten it.
↑4.3.2, Adjusting Pattern
PATTERN button, then turn Knob 1. Dialing to
Creating a Pattern
Creating Patterns
button on
GRID
Length),
MASCHINE - Getting Started - 43