Native Instruments MASCHINE MK3 Manual page 68

Setting
Prefer Project Folder
Metronome
Enabled
Auto-Enable when
Recording
Volume
Signature
Description
If this checkbox is marked, the Samples you record will be put
in a subdirectory of the folder where your Project is saved. If
not, your recordings will be saved in the generic Recordings
folder in your standard user directory (see section
Preferences – Default Page).
Check this box to activate the metronome. You can also enable
the metronome by clicking the Metronome button in the
MASCHINE Header, for more information see section:
Using the Metronome.
Click the checkbox to enable the Auto-Enable option. This
automatically turns on the metronome when you start recording
a Pattern.
When you start recording a Pattern (typically by pressing
your controller), the metronome is automatically enabled. When
you exit recording (e.g., by pressing the lit
metronome returns to its state before the recording (this can be
on or off).
The Auto-Enable option can be activated/deactivated both in the
software and from your controller.
The Auto-Enable option does not affect the Count-in: Even if
Auto-Enable is disabled, the metronome turns on when you
press SHIFT + REC to start the Count-in. For more information
on configuring Count-in, refer to section:
with Count-in.
Click the slider to adjust the volume of the metronome.
Select the time interval between each tick of the metronome. By
default the metronome indicates the beats (the quarter notes,
1/4). Here you can select another note value for the ticks.
Basic Concepts
↑2.6.4,
↑10.2.3,
REC on
REC button) the
↑10.2.4, Recording
MASCHINE - Manual - 68
Preferences