Native Instruments MASCHINE MK3 Manual page 849

◦ Click the start border of a Slice to delete that border and merge the Slice with the pre-
vious one.
◦ Click inside a Slice (i.e. anywhere between its borders) to remove the entire Slice. The
corresponding part of the Sample is grayed out and won't be exported as Slice.
DELETE ALL: Click the
▪
from scratch again.
The SLICE and REMOVE
With SLICE or REMOVE
pressing the corresponding pads on your controller!
Manually Adjusting Slices Using Your Controller
Your controller provides a dedicated Slice Edit mode that allows you to select and fine-tune
each particular Slice.
After creating slices in Live Slice mode (refer to
to edit them:
1. In SLICE mode:
2. Press the right page button to access Page 2 Edit.
3. Turn Knob 1 to select a slice to edit.
4. Turn Knob 3 to trim the start of the selected slice.
5. Turn Knob 4 to trim the end of the selected slice.
6. Press Button 8 to apply the slice.
DELETE ALL button to delete all proposed Slices and start slicing
buttons are mutually exclusive.
enabled, you can still prelisten to your individual Slices by
↑16.4.3, Live
Sampling and Sample Mapping
Slicing) use the following steps
MASCHINE - Manual - 849
Slicing a Sample