Adjusting The Length Of A Section Using The Controller - Native Instruments MASCHINE MK3 Manual

The Scene will be shortened, and if the adjustment is shorter than the referenced Pattern
→
a small Truncated Clip marker will appear on the right-hand side of the Section to indi-
cate that a part of the Scene is hidden. Only the visible part of the Scene will be audible
during playback.
When adjusting the size of a Section the following rules apply:
▪ The value set in the Arrange Grid is used for length increments. For more information on
Arrange Grid, read:
▪ When [Shift] is pressed while changing the length, the value set in the Step Grid is used.
For more information on Step Grid, read:
Grid.
▪ The minimum length a Section marker can be dragged without modifier is one Arrange Grid
increment.
▪ When [Shift] is pressed, the minimum length a Section marker can be dragged is one Step
Grid increment.
▪ The minimum length of a Section equals the minimum Scene length. This can only be ach-
ieved if Arrange Grid or Step Grid is set to Off.

15.3.6.2 Adjusting the Length of a Section Using the Controller

To adjust the length of a Section using your hardware controller:
1. Press SHIFT + SCENE
2. Press SCENE (Section) to enter Section mode.
3. Select the pad relating to the Scene you want to adjust.
4. Turn Knob 4 to adjust the length of the Section as required. Turning the knob left will
shorten the Section, turning it right will lengthen the Section.
↑15.6, The Arrange Grid.
↑10.1.7, Adjusting the Step Grid and the Nudge
(Section) to enter Arranger view.
Working with the Arranger
Using Arranger View
MASCHINE - Manual - 791