Native Instruments MASCHINE MK3 Manual page 313

Parameter
Start
Decay
Cutoff
Volume
MODWHEEL DESTINATION
Here you can determine how incoming MIDI data sent by the Modulation Wheel affects various
parameters.
Parameter
Start
Cutoff
LFO Depth
Pan
Modulation Destination
Start parameter of the PITCH / GATE
page (page 2). Positive values shift the Sample start position later in
time as you play harder, negative values shift it closer to the
beginning of the Sample as you play harder.
Tip: a typical example for this parameter is setting it so that the
initial attack transient of a snare drum is heard only at high velocity
values. This makes it sound "snappier" when you play hard, and
"muffled" or muted when you play softly.
Decay parameter of the
Pitch / Envelope page (page 2).
Cutoff parameter of the
BP2 only) on the FX / Filter
This allows you to modulate the volume, which is what velocity
normally is used for.
Modulation Destination
Start parameter of the PITCH / GATE
page (page 2).
Cutoff parameter of the
BP2 only) on the FX / Filter
Use this knob to adjust how much the Modulation Wheel affects the
depth of the LFO modulation (for all targets) defined on the
page (page 5).
Pan parameter on the Audio
(see ↑11.1.2, Configuring the Main Output of Sounds and Groups
more information).
section on the
AMPLITUDE ENVELOPE
FILTER section (with filter types LP2, HP2,
page (page 3).
section on the
FILTER section (with filter types LP2, HP2,
page (page 3).
page of the Sound's Output properties
Working with Plug-ins
The Sampler Plug-in
Pitch / Envelope
section on the
Pitch / Envelope
LFO
for
MASCHINE - Manual - 313