Native Instruments MASCHINE MK3 Manual page 836

Parameter Description
AUTO DTCT If
detects the tempo of the original audio.
(Auto Detection,
Beat mode only)
SRC BPM SRC BPM
audio (in BPM). This tempo is defined in different ways according to
(Source BPM, Beat
the
mode only)
If
original audio. You can choose between 1/2, 1, and 2 bars. The
number between brackets indicates the resulting tempo (in BPM)
derived from the number of bars you have set and the computed
tempo value.
If
original audio (in BPM).
NEW BPM Defines the target tempo of the time-shifted audio (in BPM).
(Beat mode only)
LENGTH If
audio (in bars). Please note that any change to the
(Stretch Length,
(see above) will be automatically mirrored by this
Beat mode with Auto
you have set the number of bars in the source audio, you can set here
Detection enabled
another number of bars, thereby dividing or multiplying the tempo of
only)
the target audio. Available values are 1/16, 1/8, 1/4, 1/2, 1, 2, 4, and
8 bars, as well as the corresponding triplet values.
SPEED Adjusts the new tempo relative to the original tempo (in percentage).
The minimum value is 10 %.
(Free mode only)
In Beat mode, if you set a target tempo
original tempo (SRC
higher target tempo to enable the button again!
AUTO DTCT (Auto Detection) is enabled, MASCHINE automatically
(Source BPM) allows to define the tempo of the original
AUTO DTCT value:
AUTO DTCT is enabled, you can set the length (in bars) of the
AUTO DTCT is disabled, you can directly define the tempo of the
AUTO DTCT is enabled, you can define the length of the target
(NEW
BPM), Button 8 (APPLY) will be grayed out and disabled. Set a
BPM) that is smaller than a tenth of the
Sampling and Sample Mapping
Editing a Sample
SRC BPM value
LENGTH value. Once
MASCHINE - Manual - 836