Adding Samples To The Sample Map - Native Instruments MASCHINE MK3 Manual

The ZONE page on the controller, page 5 of 5: MAP parameters.
Parameter
KEY LO (Lowest Key, Knob 1)
KEY HI (Highest Key, Knob 2)
VEL LO (Lowest Velocity, Knob 3)
VEL HI (Highest Velocity, Knob 4)
16.5.7

Adding Samples to the Sample Map

{Commented by Christian Schulz, 09.09.2016 14:10:28: from an Addendum}
You can add Samples directly to the Map view of the
To see the Map view, make sure that the Sample View button is disabled next to the
Zone tab at the top of the Sample Editor. If this is not the case, click it to disable it.
To add a new Sample, select one from the Browser or from your operating system and
►
drag it onto the Sample Map of the Map view (the biggest part in the middle of the
page). Once your mouse is hovering the Sample Map, and before you release the mouse
button:
▪ Drag your mouse horizontally to choose the root key of the new Zone.
Description
Sets the lowest note (key) of the focused Zone.
Sets the highest note (key) of the focused Zone.
Defines the lowest velocity of the focused Zone.
Defines the highest velocity of the focused Zone.
Zone page.
Sampling and Sample Mapping
Mapping Samples to Zones
Zone
MASCHINE - Manual - 881