Mapping Samples To Zones - Native Instruments MASCHINE MK3 Manual

4. Press Button 8 (APPLY) to export the selected Slice.
APPLY: Exporting the Slices to the Same Sound
On the SLICE page, press Button 8 (APPLY) to export all Slices to the focused Sound it-
►
self.
The Sample currently loaded in that Sound will be replaced by its own Slices, each of
→
them being mapped to a particular note.
This is equivalent to pressing Button 7
ready are preparing the Slices.
16.5

Mapping Samples to Zones

Mapping Samples is a way to create Sounds with more than one Sample across the MIDI key-
board and with different velocities. You can create and adjust Zones that define a key (or pitch)
range and a velocity range for each Sample included in the Sound. In other terms, the Sample
will be triggered only if the played note is within its Zone's key range and velocity range.
The Zones can overlap, allowing you to trigger different Samples at once or triggering different
Samples depending on how hard you hit the pads. You can adjust various playback settings for
the Sample of each Zone individually. The set of all Zones define the Sample Map (or "Map" for
short) of the Sound.
16.5.1 Opening the Zone Page
Mapping is done in the
Select a Sound slot, then open the Sample Editor (by clicking the button with the wave-
►
form icon on the left of the Pattern Editor), and click the
(APPLY
Zone page of the Sample Editor.
TO) and selecting the Sound in which you al-
Zone tab to show the
Sampling and Sample Mapping
Mapping Samples to Zones
Zone page.
MASCHINE - Manual - 859