Native Instruments MASCHINE MK3 Manual page 878

Hide thumbs Also See for MASCHINE MK3:
Table of Contents

Advertisement

Parameter
START
(Knob 1)
END
(Knob 2)
Hold
SHIFT
when turning the Knobs to adjust the parameters in finer increments.
In the waveform on the right display, the regions outside the play range are grayed out.
Page 2 – LOOP Parameters
The parameters in the
LOOP
while the note is held.
The ZONE page on the controller, page 2 of 5: LOOP parameters.
Parameter
ACTIVE
(Knob 1)
START
(Knob 2)
Description
Adjusts the playback's start point in the Sample of the focused Zone.
Adjusts the playback's end point in the Sample of the focused Zone.
page allow you to define and adjust a portion that will play in loop
Description
Enable this to define a loop in the Sample of the focused Zone.
When the play position reaches the loop, the playback is looped as
long as the note is held. This can be useful to loop either a whole
Sample or part of it, e.g., to simulate a longer tone. Note: this
technique requires that you set the Sampler's
or
ADSR
in the
PITCH / GATE
↑6.2.2, Page 2: Pitch /
Adjusts the start point of the loop.
TYPE
section (Parameter page 2, see
Envelope).
Sampling and Sample Mapping
Mapping Samples to Zones
selector to
AHD
MASCHINE - Manual - 878

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents