Native Instruments MASCHINE MK3 Manual page 571

Hide thumbs Also See for MASCHINE MK3:

Table of Contents

In the left part of the Assignment area, click the

tab lights up and the

ready to configure MIDI and host automation for the parameters in the current Parameter

Once the Assignment area is open, when you switch to other Parameter pages the As-

signment area follows your selection: it always shows the assignments for the page cur-

rently displayed above.

MASCHINE 1.x owners: In previous MASCHINE versions MIDI/host automation was only

possible via the Macro Controls. Now MIDI/host automation and Macro Controls are un-

related: MIDI/host automation can be configured directly on parameters, independently

of your Macro Control assignments. Macro Controls now specifically serve as shortcuts

(or "aliases") for parameters — see section

with the Macro Controls

pane holds two tabs:

▪ MIDI tab: Click the

then remote control and automate MASCHINE parameters from any MIDI-capable device or

software. Possible MIDI messages are Pitch wheel, Program Change, and MIDI CC 0–127.

▪ Host tab: Click the

SCHINE is running as a plug-in. You can then remote control and automate MASCHINE

parameters from your host application.

Under each automatable parameter of the current Parameter page, the Automation pane shows

an Assignment field showing the current assignment for this parameter, if any. If the parameter

has no assignment yet, the Assignment field reads

the parameter cannot be automated, its Assignment field is grayed out and inactive (see below

to know which parameters can be automated).

for more information.

tab to assign MIDI messages to automatable parameters. You can

tab to assign automation IDs to automatable parameters if MA-

Audio Routing, Remote Control, and Macro Controls

pane appears on its right. You are now

↑11.3, Creating Custom Sets of Parameters

Using MIDI Control and Host Automation

Enable (Host

MASCHINE - Manual - 571

Show Quick Links

Table of Contents