Native Instruments MASCHINE MK3 Manual page 576

Hide thumbs Also See for MASCHINE MK3:

Table of Contents

in the Assignment field of a parameter to enter Learn mode for that parame-

The Assignment field shows a blinking Learning.

Move the desired control element (knob, button, etc.) on your MIDI controller.

The Assignment field automatically displays the MIDI message type received (CC number,

for Program Change, or

Note that the assignments you create will receive MIDI messages on all channels of all enabled

For the Learn mode and the resulting MIDI control to work, MIDI must be correctly con-

figured in MASCHINE. If MASCHINE is running as stand-alone application this is done

↑2.6.3, Preferences – MIDI

cation the MIDI configuration is done in the host — see section

If there is already a MIDI assignment for the parameter, the new MIDI assignment will replace

the previous one. If you change your mind and don't want to assign any new MIDI control,

is blinking click the Assignment field again or press [Esc] on your computer key-

You cannot assign the same MIDI control to more than one parameter in MASCHINE: If

a MIDI control is already assigned to a parameter, when you assign it to another parame-

ter its first assignment is automatically deleted.

If you want to simply remove a MIDI assignment without recording a new one, do the following:

for Pitchbend). The parameter is ready to be controlled via

panel — for more details please refer to section

Page. If MASCHINE is running as a plug-in in a host appli-

Audio Routing, Remote Control, and Macro Controls

Using MIDI Control and Host Automation

↑2.5, Stand-Alone and

MASCHINE - Manual - 576

Show Quick Links

Table of Contents