Applying Effects To External Audio - Native Instruments MASCHINE MK3 Manual

Parameter
Gain
FILTER Section
Filter
Center Freq
Width
On your controller the outputs available in the
display of the Source
Note that the settings of the
other Plug-in supporting side-chain. This notably allows you to try different compressors
or different compression presets without losing the side-chain setup.
13.2

Applying Effects to External Audio

MASCHINE's flexible routing facilities allow you to apply effects to external audio as well. This
external audio can come from the inputs of your audio interface if MASCHINE is used in
stand-alone mode, or from your host if MASCHINE is used as a plug-in.
To do this, we will choose a Sound and make use of the Audio page in its Input properties.
13.2.1 Step 1: Configure MASCHINE Audio Inputs
MASCHINE's audio input configuration can be done in the software only. Furthermore, this
configuration is necessary only if you use MASCHINE as stand-alone application.
Description
Adjusts the input level of the side-chain signal fed into the Plug-in.
Activates a filter on the side-chain input. This filter can be useful to
select only a specific frequency range of the side-chain signal to
control the Plug-in.
Adjusts the center frequency of the filter.
Adjusts the bandwidth of the filter.
SOURCE
selector described above.
Side-Chain Input page stay in place when you switch to an-
Applying Effects to External Audio
parameter are labeled as in the
MASCHINE - Manual - 641
Using Effects