Renaming Scenes - Native Instruments MASCHINE MK3 Manual

Alternate Method
1. Press SHIFT + SCENE
2. Press and hold SCENE
3. Press Button 7 and 8 to select the desired Section bank.
4. Press ERASE + the pad corresponding to the Section you want to remove.
The Section is removed from the arrangement. The next Sections shift ahead to fill the
→
gap.
If the desired Section bank is already selected (or if there is only one Section bank), this
alternate method can be simplified as follows: Press
the corresponding Section!
You can also remove Sections in Section Arrange mode: press
(SCENE) to enter Section Arrange mode, then follow either of the procedures described
above.

15.3.10 Renaming Scenes

By default, Sections are named after the Scene they reference,
etc. To organize your song you can use custom names of your own. Naming is only available
from within the software, but any changes will also show up in both views of the Arranger
(Ideas view and Arranger view) and on your controller.
Renaming Scenes in the Arranger View
To rename a Scene in the Arranger view:
1. Double-click the Scene name at the top of the Arranger view.
You can also right-click ([Ctrl]-click on macOS) the Scene slot or the corresponding cell in
(Section) to enter Arranger view.
(Section) to enter Section mode.
ERASE + SCENE + pad to remove
ARRANGE then Button 1
Scene 1, Scene
Working with the Arranger
Using Arranger View
2, Scene 3,
MASCHINE - Manual - 798