Arming, Starting, And Stopping The Recording - Native Instruments MASCHINE MK3 Manual

16.2.3

Arming, Starting, and Stopping the Recording

The Start and Cancel buttons.
Click Start to arm the recording.
►
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE
Mode above):
▪ When recording in Sync mode:
◦ The recording will start at the next bar. Until then the
Waiting label and the
bar above the waveform display.
◦ Once the recording has started, the audio is recorded for the duration set by the
LENGTH control (see section
above). You can also click
Cancel to cancel the recording (in that case the recorded audio will not be saved).
▪ When recording in Detect mode:
◦ The recording will start as soon as the input signal exceeds the
Until then the
sage appears in the information bar above the waveform display. During this waiting
phase you can also start the recording manually by clicking the
cel the recording by clicking Cancel.
◦ Once the recording has started, click
or Cancel to cancel the recording (the recorded audio will not be saved).
If you want to start and stop the recording manually, you can set the
dial the THRESHOLD
cording, click Stop.
selector, see section ↑16.2.2, Selecting the Source and the Recording
Waiting for the next bar...
↑16.2.2, Selecting the Source and the Recording Mode
Stop beforehand to stop the recording at the next bar, or
Start button turns to a
Stop
down to OFF, and start the recording by clicking Start. To stop re-
Start
message appears in the information
Waiting button and the
to stop the recording (it stops immediately)
Sampling and Sample Mapping
Recording a Sample
button reads a flashing
THRESHOLD value.
Waiting for input... mes-
Waiting button or can-
MODE to Detect,
MASCHINE - Manual - 815