Table of Contents
Advertisement
Press the
SHIFT
+
►
Turn the encoder to set the volume level.
►
For more information on setting up input sources, refer to the MASCHINE Software Manual
available from the
Help
8.1.2
Adjusting Pan
Use the Smart Strips to set the left and right pan for up to eight Sounds at a time.
To adjust a Pan setting:
1.
Press
SHIFT
+
LEVEL
2.
Press the Group (A-H) containing the Sound you want to adjust. If necessary, use the left
and right arrows of the D-pad to access different Group banks.
3.
Press and hold
SELECT
⇨
Use the Page buttons to switch between Sound
update accordingly to allow the panning of each Sound to be adjusted.
4.
Slide your finger up the Smart Strip to pan the Sound right, and down to pan left. Press
SHIFT
to adjust the Pan amount in finer increments.
The Pan is adjusted accordingly.
→
8.1.3
Using Solo
Solo Mode allows you to listen to a single Group or a Sound in isolation. This is useful for iso-
lating a Group or Sound in a mix to test different sequences. It can also be used to great effect
as a performance technique, for example, to create a breakdown.
Activating Solo on a Group
1.
Press and hold
SOLO
2.
Press a Group button (A-H) to solo it. Press the Group again to turn Solo off.
IN1
(IN2) button to select input source 2.
menu
to switch the Smart Strips into Pan Mode.
and press the Sound button 1-16.
to momentarily enter Solo Mode.
1-8
or 9-16. The eight Smart Strips will
MASCHINE JAM - Manual - 128
Mixing your Project
Basic Functions
Hide quick links:
Advertisement
Table of Contents
