Native Instruments MASCHINE MK3 Manual page 550

Controls
CUE Section
Output
Level
Pan
If MASCHINE is running as a plug-in, the external stereo outputs Ext. 1–16 available in
the Output selector of the
your host.
Configuring the Master and Cue Outputs in Mix View
You can also easily configure the Master and Cue outputs of MASCHINE in the Mixer. Both
share the same channel strip at the far right of the Mixer.
To display the Master/Cue channel strip, do the following:
1. Click the Mix View button on the left of the Arranger to switch from Arrange view to Mix
view:
Description
Selects where you want to send the Cue bus of your MASCHINE
Project. Available options are the 16 external stereo outputs Ext. 1–
16. By selecting a different output from the one used for the main
stereo output, you can effectively pre-listen on this additional
output (e.g., on your headphones) any channel(s) currently sent to
the Cue bus. To send a channel to the Cue bus, enable the
switch in the Audio page of its Output properties (see section
↑11.1.2, Configuring the Main Output of Sounds and
Adjusts the level of the Cue output.
Defines the panoramic position of the Cue output in the stereo
field.
MAIN and CUE sections will correspond to virtual outputs in
Audio Routing, Remote Control, and Macro Controls
Audio Routing in MASCHINE
Cue
Groups).
MASCHINE - Manual - 550