Native Instruments MASCHINE MK3 Manual page 329

Hide thumbs Also See for MASCHINE MK3:

Table of Contents

Fade (Gate Mode

only) Set a simple fade-in fade-out amount to avoid pops or clicks that may

Source Section

occur when using the

knob clockwise by clicking and dragging upwards. To

decrease the fade, turn the

and dragging downwards. Press the [SHIFT] button on your computer

keyboard while turning the knob to increase or decrease the fade in

finer increments.

Transpose the tune (range: -36 – +36 semitones) of the Audio plug-

in. You can use this knob to set the playback pitch of the loop to 'C',

and then the loop's pitch will match the pitch of Notes programmed

into the Pattern.

To increase the tuning of the waveform, turn the

by clicking and dragging upwards. To decrease the tuning of the

waveform, turn the

dragging downwards. Press [SHIFT] button on your computer

keyboard while turning the knob to increase or decrease the tuning in

Set the Pitchbend range (-12 – +12) for the Audio plug-in which is

relative to the Tune. This parameter controls the affect of the Pitch

Wheel/Slider on your MIDI controller.

To increase the range of the Pitchbend, turn the

clockwise by clicking and dragging upwards. To decrease the range of

the Pitchbend, turn the

clicking and dragging downwards. Press the [SHIFT] button on your

computer keyboard while turning the knob to increase or decrease the

Pitchbend range in cents.

mode. To increase the fade of Gate mode,

knob counter-clockwise by clicking

knob counter-clockwise by clicking and

knob counter-clockwise by

Using the Audio Plug-in

knob clockwise

MASCHINE - Manual - 329

Show Quick Links

Table of Contents