Assigning And Removing Patterns - Native Instruments MASCHINE MK3 Manual

5. Press SHIFT and turn Knob 4 to change the Section length in smaller increments.
The Section length is adjusted accordingly.
→
To adjust the length of a Section using your hardware controller:
1. Press NAVIGATE + Button 3
2. Press SCENE to enter Section mode.
3. Select the pad relating to the Section you want to adjust.
4. Turn Knob 4 to adjust the length of the Section as required. Turning the knob left will
shorten the Section, turning it right will lengthen the Section.
5. Press SHIFT and turn Knob 4 to change the Section length in smaller increments.
The Section length is adjusted accordingly.
→
15.3.7

Assigning and Removing Patterns

Each Pattern placed in the Arranger (Ideas view or Arranger view) references one of the Pat-
terns available in the Pattern Editor for the corresponding Group.
In the Arranger view, each column represents a Section and each row represents a Group. It is
possible to assign and remove Patterns in Arranger view although it is better to use the Ideas
view as this provides a better overview of your Patterns. However, any changes made in Arrang-
er view or Ideas view is one and the same.
ARRANGER to access the Arranger view.
Working with the Arranger
Using Arranger View
MASCHINE - Manual - 792