Native Instruments MASCHINE MK3 Manual page 828

The EDIT page on the controller, page 1 of 2: adjusting the play range of the Sample.
Parameter
START (Knob 1)
END (Knob 2)
Hold SHIFT when turning the Knobs to adjust the parameters in finer increments.
In the waveform on the right display, the regions outside the play range are grayed out.
If a loop has been defined in the Sample, it is also indicated on the waveform. Loops
can be created and adjusted in the
Editing Zones in the Map
Therefore, when moving the Sample's start and end points closer to each other, keep in
mind that it might also shrink the loop!
Page 2 – SELECTION RANGE Parameters
The parameters in the
dio processing functions will be applied.
Parameter
START (Knob 1)
END (Knob 2)
Description
Adjusts the start point of the play range in the Sample.
Adjusts the end point of the play range in the Sample.
ZONE
View. Note that the loop will always stay within the play range.
SELECTION RANGE section allow you to adjust the range to which au-
Description
Adjusts the start point of the selection range in the Sample.
Adjusts the end point of the selection range in the Sample.
page — see section ↑16.5.4, Selecting and
Sampling and Sample Mapping
Editing a Sample
MASCHINE - Manual - 828