Axis Parameter Setting Example - Omron NY532-1500 User Manual

4-1-3

Axis Parameter Setting Example

Set the following axis parameters before you execute the MC Test Run Mode in the Sysmac Studio.
The following setting example is for a one-axis device.
Encoder Output Pulse Count per Motor Rotation
20 bits = 1,048,576
Axis Variable Name
Axis Number
Axis Use
Axis Type
Input Device/Output Device
Unit of Display
Command Pulse Count Per Motor Rotation
Work Travel Distance Per Motor Rotation
Maximum Velocity
Maximum Jog Velocity
Maximum Acceleration
Maximum Deceleration
Software Limits
Positive Software Limit
Negative Software Limit
Count Mode
*1 If there is more than one axis, a different variable name is set for each axis.
*2 If there is more than one axis, a different value is set for each axis.
*3 Set the same node address as for the Servo Drive.
If there is more than one axis, a different value is set for each axis.
*4 The position command unit will be 1 μm.
*5 The maximum velocity will be 3,000 r/min = 30 m/min = 0.5 m/s = 500,000 μm/s.
*6 The maximum jog velocity will be 10% of the maximum velocity, i.e., 0.05 m/s = 50,000 μm/s.
*7 The maximum acceleration and the maximum deceleration will be 5 m/s
The acceleration time to the maximum velocity (3,000 r/min) will be 0.1 s.
*8 Set a value that is within the movable range of the device.
The positive software limit is set to 50 cm = 500,000 μm.
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)
Servomotor
Encoder resolution: 20 bits/rotation
Parameter name
4 Checking Wiring from the Sysmac Studio
10 mm
Ball screw
Ball screw pitch: 10 mm
*1
Axis1
*2
1
Used axis
Servo axis
*3
1
μm
*4
1,048,576
*4
10,000
*5
500,000
*6
50,000
*7
5,000,000
*7
5,000,000
Immediate stop for command position
*8
500,000
*8
0
Linear Mode
2
.
1 rotation
Setting
4-5
4