Programming Motion Controls - Omron NY532-1500 User Manual

6-8

Programming Motion Controls

Place motion control instructions in the user program of the NY-series Controller to perform motion con-
trol. Programs that contain motion control instructions are called motion control programs.
Precautions for Correct Use Precautions for Correct Use
• You can set and program up to 64 axes on the Sysmac Studio for any model of Industrial PC.
You cannot download a project if the project contains more than the maximum number of con-
trolled axes for that Industrial PC.
• When you reuse a project, make sure that the maximum number of control axes for the Indus-
trial PC model is not exceeded.
• Even axes that are set as unused axes are included in the number of control axes.
Refer to the NY-series Industrial Panel PC / Industrial Box PC Software User's Manual (Cat. No. W558)
for details on programming.
This section gives the procedure to create a program in an existing project on the Sysmac Studio.
1
Starting the Sysmac Studio
Start the Sysmac Studio and open the project.
2
Adding a Program
Right-click Programs in the Multiview Explorer and select Multipart Ladder or Structured Text
from the Add Menu.
A program is added to the Multiview Explorer.
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)
6 Motion Control Programming
6
6-37