11-1 Overview Of Errors - Omron NY532-1500 User Manual

11 Troubleshooting

11-1 Overview of Errors

You manage all of the errors that occur on the NY-series Controller as events. The same methods are
used for all events. This allows you to see what errors have occurred and find corrections for them with
the same methods for the entire range of errors that is managed (i.e., CPU Unit, NX-series Slave Termi-
nals, and EtherCAT slaves).
However, only EtherCAT slaves as Sysmac devices are supported.
Refer to the NY-series Industrial Panel PC / Industrial Box PC Software User's Manual (Cat. No. W558)
for details on Sysmac devices.
Troubleshooting functions
Sysmac Studio
Error management range for NY-series Controller
You can use the troubleshooting functions of the Sysmac Studio or the Troubleshooter on an HMI to
quickly check for errors that have occurred and find corrections for them.
To perform troubleshooting from an HMI, connect the HMI to the built-in EtherNet/IP port on the Indus-
trial PC.
This manual describes the errors that originate in the Motion Control Function Module. Refer to the NY-
series Troubleshooting Manual (Cat. No. W564) for specific corrections when errors occur and for trou-
bleshooting information on the entire NY-series Controller. For information on errors that occur when
motion control instructions are executed, refer to each instruction in the NY-series Motion Control
Instructions Reference Manual (Cat. No. W561).
Precautions for Correct Use Precautions for Correct Use
Refer to the appendices of the NY-series Troubleshooting Manual (Cat. No. W564) for the
applicable range of the HMI Troubleshooter.
11-2
Host computer
EtherNet/IP
NY-series
Controller
EtherCAT
Built-in EtherCAT port
EtherCAT
slaves
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)
HMI
Troubleshooter
Built-in EtherNet/IP port