Motion Control Instructions; Function Blocks For Plcopen® Motion Control; Motion Control Instructions Of The Mc Function Module - Omron NY532-1500 User Manual

6-2

Motion Control Instructions

Motion control instructions are used in the user program to execute motion controls for an NY-series
Controller. These instructions are defined as function blocks (FBs). The motion control instructions of
the MC Function Module are based on the technical specifications of function blocks for PLCopen
motion control. There are two types of motion control instructions: PLCopen
instructions that are unique to the MC Function Module. This section provides an overview of the PLCo-
®
pen motion control function blocks and gives the specifications of the MC Function Module.
Refer to the NY-series Industrial Panel PC / Industrial Box PC Software User's Manual (Cat. No. W558)
for basic information on the NY-series function blocks (FBs).
Refer to the NX-series Position Interface Units User's Manual (Cat. No. W524) for information on using
the NX-series Position Interface Units.
6-2-1 Function Blocks for PLCopen
®
PLCopen standardizes motion control function blocks to define a program interface for the languages
specified in IEC 61131-3 (JIS B 3503). Single-axis positioning, electronic cams, and multi-axes coordi-
nated control are defined along with basic procedures for executing instructions.
By using PLCopen
out hardware dependence. Costs for training and support are also reduced.
Additional Information
PLCopen
PLCopen
world-wide membership. IEC 61131-3 is an international standard for PLC programming.
• The website of headquarters of PLCopen
6-2-2

Motion Control Instructions of the MC Function Module

There are three types of motion control instructions. They are given in the following table.
Type
Common commands
Axis commands
Axes group commands
For a list of the instructions that you can use with the MC Function Module, refer to the NY-series
Motion Control Instructions Reference Manual (Cat. No. W561).
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)
®
motion control function blocks, the user program can be more easily reused with-
®
®
is an association that promotes IEC 61131-3. It has its headquarters in Europe and a
Common instructions for the MC Function Module
Instructions for MC Function Module to perform single-axis control
Instructions for MC Function Module to perform multi-axes coordinated control
6 Motion Control Programming
®
Motion Control
®
in Europe is http://www.plcopen.org/.
Outline
®
®
-defined instructions and
6-3
6