Axes Group Basic Settings - Omron NY532-1500 User Manual

5 Motion Control Parameters
5-3-2

Axes Group Basic Settings

Set whether to use the axes group. If you are going to use the axes group, set the axis configuration
and the axes to use.
Parameter name
Axes Group Number Set the logical number of the axes group. This number
Axes Group Use
Composition
Composition Axes
*1 An error occurs if you execute the MC_GroupEnable (Enable Axes Group) instruction for an axes group that
contains an unused axis.
Composition
The following table lists the axis compositions you can use with the MC Function Module. Use the Sys-
mac Studio to set the axis composition according to the actual devices.
Composition
2 axes
3 axes
4 axes
5-30
Function
specifies which of the following system-defined vari-
ables to use: _MC_GRP[0-31].
Set whether to enable or disable the axes group. An
error occurs if you execute a motion control instruction
for an undefined or unused axes group.
0: Undefined axes group
1: Unused axes group
2: Used axes group
Set the axis composition of the axes group.
0: 2 axes
1: 3 axes
2: 4 axes
Sets the axis number to assign to the axes group. Set
Axis Variable names from the Sysmac Studio to use for
the A0 to A3 axes.
A two-axis configuration is used. For example, a machine with a two-axis Carte-
sian coordinate system is used.
A three-axis configuration is used. For example, a machine with a three-axis
Cartesian coordinate system is used.
A four-axis configuration is used. For example, a machine with a three-axis Car-
tesian coordinate system is used with a rotary axis at the end tool.
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)
Setting range
---
0 to 2
*1
0 to 2
2 to 4 axes
Description
Default
---
0
0
0