Omron NY532-1500 User Manual page 82

3 Configuring Axes and Axes Groups
Additional Information
Changing Axes Group Variable Names in the User Program
Perform the following two procedures to change Axes Group Variable names that are already
used.
• Change the Axes Group Variable name in the variable table in the variable declarations.
• Change the Axes Group Variable name in the user program.
Even if you change the Axes Group Variable names in the variable table, the Axes Group Vari-
able names in the user program do not change. An error will occur if you use a variable name
that is not declared in the variable table, in the user program. Always change the names in both
places.
Downloading to the Controller
Use the Synchronization menu command of the Sysmac Studio to download the project to the NY-
series Controller.
1
Select Online from the Controller Menu. The Sysmac Studio goes online with the Controller.
2
Select Synchronization from the Controller Menu and then click the Transfer to Controller
Button.
3-28
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)