Omron NY532-1500 User Manual page 71

Right-click Axis Settings in the Multiview Explorer and select Axis Setting Table to enable setting the
axes parameters for all axes at the same time.
Precautions for Correct Use Precautions for Correct Use
When making operation settings such as the display unit, electronic gear (unit conversion for-
mula), maximum velocity, or maximum acceleration/deceleration, be sure to use appropriate val-
ues for the operating conditions of the device.
Additional Information
Changing Axis Variable Names in the User Program
Perform the following two procedures to change Axis Variable names that are already used.
• Change the Axis Variable name in the variable table in the variable declarations.
• Change the Axis Variable name in the user program.
Even if you change the Axis Variable names in the variable table, the Axis Variable names in the
user program do not change. An error will occur if you use a variable name that is not declared in
the variable table, in the user program. Always change the names in both places.
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)
3 Configuring Axes and Axes Groups
3
3-17