Omron NY532-1500 User Manual page 72

3 Configuring Axes and Axes Groups
Downloading to the Controller
Use the Synchronization menu command of the Sysmac Studio to download the project to the NY-
series Controller.
1
Select Online from the Controller Menu. The Sysmac Studio goes online with the Controller.
2
Select Synchronization from the Controller Menu and then click the Transfer to Controller
Button.
Additional Information
Introduction to Servo Drive Settings
The MC Function Module connects to OMRON 1S-series Servo Drives with built-in EtherCAT
communications, G5-series Servo Drives with built-in EtherCAT communications, or NX-series
Pulse Output Units.
Connectable Servo Drive Models
You can connect the R88D-1SN-ECT, R88D-KN-ECT and R88D-KN-
ECT-L Servo Drives.
The R88D-KN-ECT-R Servo Drives support only Position Control Mode (Cyclic Syn-
chronous Position Control Mode). Therefore, any functions that use Velocity Control Mode
(Cyclic Synchronous Velocity Control Mode) or Torque Control Mode (Cyclic Synchronous
Torque Control Mode) cannot be used.
Servo Drive Settings
The MC Function Module uses some of the input signals and functions of the Servo Drives.
Servo Drive signal wiring and object setting are required to use the MC Function Module
properly. Refer to A-1 Connecting the 1S-series Servo Drive or A-2 Connecting the G5-
series Servo Drive for specific settings.
Refer to the NX-series Position Interface Units User's Manual (Cat. No. W524) for the settings to
use NX-series Pulse Output Units.
3-18
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)