Omron NY532-1500 User Manual page 60

3 Configuring Axes and Axes Groups
Classification
Unit Conversion
Settings
Position Count
Settings
Limit Settings
*1 For example, if the encoder resolution is 10,000 pulses/rotation, set 10,000.
Precautions for Correct Use Precautions for Correct Use
• Select the appropriate values based on the machine's operating conditions for parameters
such as the maximum velocity, maximum acceleration/deceleration, or stop settings when the
motor is actually operated.
• OMRON 1S-series Servo Drives and G5-series Servo Drives can be set to specific node
addresses by using the rotary switches on the front panels. If the rotary switches are set to 00,
the node address will be determined by the settings made in the EtherCAT Editor of the Sys-
mac Studio. If the rotary switches are set to 00 for all connected Servo Drives, errors will not
occur even if the Servo Drive's connection position is changed. Set the node addresses on the
rotary switches to assign specific Servo Drives for each machine control.
3-6
Parameter name
Unit of Display Select the display unit (mm, degrees, etc.).
Command Pulse Count Set the number of command pulses per motor
Per Motor Rotation
rotation according to the encoder resolution.
Work Travel Distance Set the workpiece travel distance per motor rota-
Per Motor Rotation tion according to the machine specifications.
Specify whether to use the reducer setting or not.
Reducer Use
Work Travel Distance Set the work travel distance per rotation.
Per Rotation
Set the gear ratio for the workpiece.
Work Gear Ratio
Set the gear ratio of the motor.
Motor Gear Ratio
Count Mode Set this parameter according to the machine
specifications.
Software Limits Set this parameter according to the device speci-
fications.
NY-series Industrial Panel PC / Industrial Box PC Motion Control User's Manual (W559)
Setting
*1
Page
P. 5-10
P. 5-22
P. 5-22