Instructions Related To Nx Message Communications Errors - Omron NY532-5400 Reference Manual

Appendices
A-3 Instructions Related to NX Message
Communications Errors
If too many of the following instructions are executed at the same time, an NX Message Communica-
tions Error may occur. If an NX Message Communications Error occurs, reduce the number of the fol-
lowing instructions that are executed. The conditions for an NX Message Communications Error
depends on factors such as the communications traffic.
Classification
System Control Instruc-
tions
EtherCAT Communica-
tions Instructions
IO-Link Communications
Instructions
A-20
Instruction
RestartNXUnit Restart NX Unit
NX_ChangeWriteMode Change to NX Unit Write Mode
NX_SaveParam Save NX Unit Parameters
NX_ReadTotalPowerOn- Read NX Unit Total Power ON Time
Time
EC_CoESDOWrite Write EtherCAT CoE SDO
EC_CoESDORead Read EtherCAT CoE SDO
EC_StartMon Start EtherCAT Packet Monitor
EC_StopMon Stop EtherCAT Packet Monitor
EC_SaveMon Save EtherCAT Packets
EC_CopyMon Transfer EtherCAT Packets
EC_DisconnectSlave Disconnect EtherCAT Slave
EC_ConnectSlave Connect EtherCAT Slave
EC_ChangeEnableSet- Enable/Disable EtherCAT Slave
ting
NX_WriteObj Write NX Unit Object
NX_ReadObj Read NX Unit Object
IOL_ReadObj Read IO-Link Device Object
IOL_WriteObj Write IO-Link Device Object
Name
NY-series Instructions Reference Manual (W560)
Page
2-836
2-843
2-848
2-854
2-900
2-903
2-908
2-914
2-916
2-918
2-920
2-927
2-929
2-946
2-961
2-970
2-979