Installing An Sfp Transceiver In An Ln1000-V Rtm; Figure 8: Location Of The Rear Transition Module In Relation To The Ln1000-V - Juniper LN1000-V Hardware Manual

LN1000-V Mobile Secure Router Hardware Guide
LN1000-V Router
Installing an SFP Transceiver in an LN1000–V RTM
30
Figure 8: Location of the Rear Transition Module in Relation to the
LN1000-V Router
Chassis midplane
Remove the slot filler panel from the selected node board slot, if necessary.
3.
Prepare the rear transition module by manually loosening the locking screws and
4.
opening the injector/ejector latches at the top and bottom of the rear transition
module.
Carefully align the edges of the module with the guides in the appropriate slot.
5.
Taking care to keep the module aligned in the guides, slide the module in until the
6.
injector/ejector latches engage in the chassis retention bars.
Simultaneously push in the rear transition module and rotate the injector/ejector
7.
mechanisms inward to their closed positions to seat the midplane connectors.
Tighten the module retention screws to ensure that the rear transition module is
8.
secured into the shelf.
You can install up to eight SFP transceivers in the LN1000–V rear transition module
(RTM). The SFP transceivers are hot—removable and hot-insertable. You can remove
and replace them without powering off the LN1000–V router or disrupting router functions.
WARNING: Do not look directly into transceivers or into the ends of fiber-optic cables
connected to a transceiver. Fiber-optic transceivers emit laser light that can damage
your eyes.
CAUTION:
LN1000-V
Rear Transition Module
Copyright © 2010, Juniper Networks, Inc.